Categories

Categories

Roughness and Blasting Profile

Partneři


Povrchová úpravaOdborný server


Tvrdoměry materiálů, stolní, přenosnéTvrdoměry


Replica tape for measuring blasted surface profiles

LD2066, LD2067, LD2070, LD2071

-TQC Sheen

Replica tape for measuring blasted surface profiles. By placing the Tqc replica tape on the surface and rubbing over it, the Rt (total roughness) or peak-to-valley height of the profile can be taken and then measured with a film thickness meter.

More details

Replica tape for measuring blasted surface profiles. By placing the Tqc replica tape on the surface and rubbing over it, the Rt (total roughness) or peak-to-valley height of the profile can be taken and then measured with a film thickness meter.


1. TQC Replica tape consists of a layer of compressible foam affixed to an incompressible polyester substrate. 
2.When pressed against a roughened/gritblasted (steel) surface, the foam collapses acquiring an impression of the surface. 
3.Placing the compressed tape between the anvils of the SP1570 micrometric thickness gage, and subtracting the contribution of the incompressible substrate (50 micrometers or 0.002 inches), gives a measure of the surface profile. 

One box of Testex contains tape for 50 measurements.

ORDERING INFORMATION

Art. No. LD2065

Type Testex-tape Medium, range 5-7 microinch / 0.1-2µm
Not to be used with a film thickness meter

Art. No. LD2066

Type: Testex-tape coarse Minus, range 0.5 to 1.0 mils/ 12 to 25 µm

Art. No. LD2071

Type: Testex-tape COARSE range: 0.8 to 2.5 mils / 20 to 64 µm


Art. No. LD2070

Type: Testex-tape X-COARSE range:1.5 to 4.5 mils / 38 to 115 µm

Art. No. LD2067

Type: Testex-tape X-coarse Plus, range 4.6 to 5.0 mils / 116 to 127 µm

15 other products in the same category

Send a message

Replica tape for measuring blasted surface profiles

Replica tape for measuring blasted surface profiles

We will never spam you

What can we do for you?

Product successfully added to the product comparison!